WEG MW500 User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
www.weg.net
MW500 - MotorDrive14
Technical Data
Power supply
Voltage and power range
1-phase, 200-240 V ac (+10%-15%)
0.75 and 1.1 kW (1 and 1.5 HP)
1-phase/3-phase, 200-240 V ac (+10%-15%)
0.25 to 3 HP (0.25 to 2.2 kW)
3-phase, 200-240 V ac (+10%-15%)
2 to 7.5 HP (1.5 to 5.5 kW)
3-phase, 380-480 V ac (+10%-15%)
1.1 to 4 kW (1.5 to 5 HP)
Supply frequency 50/60 Hz (48 Hz to 62 Hz)
Motor connection
Voltage 3-phase, 0-100% of supplied voltage
Output frequency 0 a 500 Hz
Displacement power factor >0.97
Overload capacity 1.5 x In (drive) for 1 minute every 6 minutes
Switching frequency Default 5 kHz (selectable 2.5 to 15 kHz)
Aceleration time 0.1 to 999s
Deceleration time 0.1 to 999s
Environment
Temperature
40 ºC - for wall mounting installation
50 ºC - for motor mounting installation using self-ventilation
2% of current derating for each ºC above the specific operating temperature, limited to an increase of 10 ºC
Humidity 5% to 95% non-condensing
Altitude
Up to 1,000 m - rated conditions
1,000 m to 4,000 m - 1% of current derating for each 100 m above 1,000 m of altitude
Protection degree IP66/NEMA 4X (the disconnect switch is IP65)
Performance
V/f control
Speed regulation: 1% of the rated speed (with slip compensation)
Speed variation range: 1:20
Vector control (VVW)
Speed regulation: 1% of the rated speed
Speed variation range: 1:30
Braking methods
DC current applied to motor
dynamic braking
Available as standard for frame size B. For frame size A “DB” models has to be used.
An extra resistor must be fitted in for dynamic braking capability
Safety Protection
Overcurrent/phase-phase short circuit in the output
Overcurrent/phase-ground short circuit in the output
Under/overvoltage
Overtemperature in the heatsink
Overload in the motor
Overload in the power module (IGBTs)
External alarm / fault
Setting error
Page view 13
1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments